O P E R A T I N G I N S T R U C T I O N S QP, QPXU Battery Chargers For Industrial Use: Designed for gel, we
After a full charge the LED is green with a yellow flash The batteries did not reach 80% charge in 12 hours, or did not reach minimum voltage,
NOTE: It does not matter what position the meter switch is in. It is for viewing and not operating. EQUALIZATION: When using multiple bat
DO NOT USE THIS CHARGER ON A TWO POLE UNGROUNDED OUTLET OR ATTEMPT TO BREAK OFF THE GROUND PRONG FOR USE ON A RECEPTACLE OR EXTENSION CORD NO
With wet cell batteries, maintain the proper electrolyte level by adding water when necessary. Never allow the electrolyte level to fall
Illustration of series and parallel battery connections. Parallel Series REPROGRAMMIN
NOTE: The #1 position is designated for batteries requiring long finish rates. If your performance is poor, it could be the batteries are
TROUBLES HOOTING Symptom Cause Corrective Action No voltage reading on meter when connected to battery, and the LED flashes red/green. Connected
The battery voltage reads well below the rating of the battery, and when powered up the LED is red with a yellow flash, and the amps are less than
Kommentare zu diesen Handbüchern